[. . . ] Dear Customer, Before using the appliance, please read the following instructions carefully. Connection to the mains supply Make sure that the supply voltage corresponds with the voltage marked on the rating label. [. . . ] If repairs are needed, please send the appliance to one of our customer service departments. Switch off the appliance afterwards and allow the motor to cool down before switching it on again. Start up Before the juicer is used for the first time, it must be cleaned as described in the section General Cleaning and Care. Fit the small press-down dome onto the pulp sieve; then attach the sieve to the juice container in such a way that the sieve handle is positioned above the container handle. When processing larger citrus fruits such as oranges, the large press-down dome can be fitted over the smaller one. Cut the citrus fruit in half and push one of the halves lightly down onto the dome with the cut section facing downwards. The motor can rotate in either direction and may also change direction during operation. When processing larger quantities of fruit, the pulp sieve must be emptied from time to time as necessary. Always remove the plug from the wall socket before pouring out the juice. To pour out the extracted juice, remove the pulp sieve from the juice container, then unlock the juice container from the base unit by turning the container in an anti-clockwise direction. - For periods of non-use, attach the pulp sieve and the dust cover to the appliance after cleaning. Power cord storage The power cord may be wound round the appliance during periods of non-use. [. . . ] - The attachment parts should be thoroughly cleaned immediately after processing, using hot water and a mild detergent. Anslutning till vägguttaget Se till att nätspänningen i vägguttaget motsvarar den som är märkt på apparatens skylt. [. . . ]